ISO 300L Toothpaste Manufacturing Equipment , SUS316L Cosmetic Making Machine

Main Features:

The structural features of the paste making machine are:
(1) The cylinder is made of three-layer, stainless steel material inside and outside, the positive pressure resistance is 0.2MPa, the negative pressure resistance is -0.1MPa, the jacket is used for heating or cooling, and the positive pressure resistance is 0.3Mpa.
(2) The scraper stirring is that the large wall-mounted scraper and the central scraper rotate in positive and negative directions. During stirring, the material can be scraped off the wall of the cylinder, the temperature is transmitted evenly and fully, and the effect of turning up and down is formed.
(3) High-speed homogenizer, the speed is 3600RPM, and the gap between the inner and outer rotors is 1-2mm. After the powder is inhaled from the bottom, it is ejected to the top through the homogenizer, so as to achieve the effect of making the paste fine. (4) The vacuum pump adopts a water-sealed two-stage vacuum pump, and is equipped with a buffer tank between it and the paste making pot to isolate the materials that are accidentally brought out.
(6) The jacket cooling adopts circulating water, the water pressure is controlled below 0.3Mpa, and the temperature is set by the control system.
(7) The discharge port is located at the bottom of the paste making pot, and the material is discharged by a colloid pump with a flow rate greater than 100L/min.

Toothpaste Production Line:

Our Service:

We provide Turn-key project service to customer.
1. Factory Layout design;
2. Factory Decoration based on GMP standard;
3. Formula of products;
4. Raw material etc;
5. Machine design, whole production line from A to Z;
6. Shipping service, FOB, CFR, CIF etc;
7. Installation service. Training service, maintain.